AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Best free led sign programming software2/21/2024 ![]() Leave the remaining fields blank then, select Ok, and then close.Now, select 'Use the following IP address, then enter the following IP address: 10.1.10.127.Right-click on your Ethernet Adapter and select properties.Select Network and sharing center and then change adapter options.Connect the computer to the Signcity network, then proceed to the next step.To maintain the best connection, position the Access point and Client within the line of sight of each device. Three (3) lights indicate that you have an excellent connection to the access point.The three lights above display the signal strength. You may notice that the LAN light intermittently flashes. The first two lights, Power and Lan, should be constantly lit.You can verify that you have a good connection by looking at the lights on the Client. Wait for the access point to power on, and all the lights are lit.To power the Access point, plug the ethernet cable into the POE port on the POE injection. Use the provided POE injector to connect the power to the access point.Connecting wirelessly: Connect the Client to the antenna port on the sign.When using the access point and Client together, you can connect wirelessly over Wi-Fi or directly with the provided LAN/Ethernet cables. Using the Client and the Access point together extends the Network and lets you connect over a further distance. After you connect, open the Viplex Express and move to the next step.Open your Wi-Fi settings and connect to the Signcity network (enter password above). ![]() To use this method, connect the Access Point to your sign and wait for all lights on the side to be lit.The local Network is called ' Signcity' out of the box, and the password is Signcity123. The access point will create a local network. Using just the access point is possible if your office is close to the sign. There are two ways to connect your computer to the sign using the CPE antennas. The CPE antenna creates a local network that you can use to connect to your sign. Below are the steps for connecting with the CPEs or optional 4G modem. You may have two CPE antennas, a Client, and Access Point, depending on your selections. ![]()
0 Comments
Read More
Leave a Reply. |